-40%
Valken Lipo 7.4v 2500mAh 15/25C Split (Small Tamiya)
$ 24.25
- Description
- Size Guide
Description
DESCRIPTIONThe Valken 7.4v 2500mAh Split Type Lipo airsoft battery is a high performance lithium airsoft gun battery. This lithium battery has an initial burst discharge rate of 25C, and a constant discharge rate of 15C. This nunchuck Lipo battery has no memory effect, and does not require discharging. This butterfly Lipo battery can hold a charge for months, and features a small Tamiya plug and XH 3-pin charging connector. They fit inside most full stocks and crane stocks.
CANNOT SHIP VIA AIR. SHIPS WITHIN UNITED STATES VIA GROUND ONLY.
Valken LiPo Battery Safety Manual
COMPATIBLE PRODUCTS
Valken 2-3 Cell Lithium Smart Charger with Digital Display
Valken Lithium Battery Charging and Travel Safety Sack
Valken Battery Tester and Power Analyzer
Battery Safety Mascot
IMPORTANT INFORMATION:
Watch the 3 safety videos below if you are unfamiliar or new to charging airsoft batteries for safe and proper care, maintenance, and use of all type of airsoft battery packs and chargers.
OPERATION INSTRUCTIONS
Always charge your new battery fully before its first use.
Connect the DC power or AC adapter to the proper Lipo & Li-ion charger. Do not use a NiMh charger.
Plug the charger's power into an appropriate wall outlet.
Connect the battery pack to the charger with the small XH charging connector and make sure the polarity is connected in the right way.
Place battery inside a Lithium Battery Safety Bag while charging.
Once fully charged, disconnect battery pack from charger before unplugging the charger from the wall outlet.
WARNING!
Never leave the charger unattended while it is connected to power supply.
Never attempt to charge more than 1 battery pack simultaneously from the same charger.
Only use the appropriate charger with your LiPo & Li-Ion batteries. Use of other chargers can result in fire, personal injury and property damage.
Never leave batteries and chargers unattended when in use. Always remove the battery from the charger or airsoft gun when not in use.
Always charge batteries in a safe area, on a stable non-flammable, heat-resistant, and non-conductive surface away from other flammable items. Unsafe charging surfaces include, but not limited to, car seats, carpet, bed, or something similar that can heat up quickly and melt or catch fire.
Never allow your battery and charger to be dislodged or fall during charging as this can result in fire, personal injury and property damage.
Never alter, modify or open your battery pack or charger.
Terminate charging immediately when any malfunction is observed.
Cancer and Reproductive Harm - www.P65Warnings.ca.gov
CAUTION!
Before charging complete a visual inspection of your battery and charger. At the sign of any damage or short circuit, do not use.
Never expose Li-Po & Li-Ion batteries to temperatures higher than 160 degrees F.
Never leave your Li-Po & Li-Ion battery in a closed vehicle.
Never use any charger accessory, such as wires extensions, adapters, or multi-connector adapters, that were not included with your charger from the factory. They may not be compatible with your charger and result in fire, property damage, or personal injury.
Any service or modification of any Li-Po & Li-Ion battery must be completed by a qualified dealer or original manufacturer.
Always keep your battery in a safe secure location to prevent damage during transport or storage.
Always keep batteries away from liquids.
Always keep batteries out of the reach of children.
Don't charge the following types of batteries:
Lead Acid battery or VRLA.
NiMh or NiCd battery packs.
Non-rechargeable battery (explosion hazard)
Faulty or damaged battery.
Battery pack which consists of different types of cells.
Any other type of battery except for Li-Po and Li-Ion battery packs.
FEATURES
High performance Lithium Polymer cells
25C burst discharge rate
No memory effect
SPECIFICATIONS
Configuration: Split (2 Cells)
Dimensions: 2x 127mm x 20mm x 10mm
Plug type: Small Tamiya
Charging plug type: BMS / XH 3-Pin Charging Connector
Specifications: 7.4v / 2500mAh
Output: 25C Burst, 15C Constant
Charger: Not Included